This article introduces the setting method of "Verification", which is suitable for finding the corresponding configuration barcode and completing parameter adjustment.
Applicable to:
E900
Questions
- How to set up verification?
- Where is the verification configuration barcode?
- How to adjust the verification parameters?
Resolution / Answer
This setting is used to configure the communication method or communication parameters between the device and the host. Usually when connecting to a computer, serial device, RS485/Modbus network or access control Wiegand system, you need to ensure that the parameters at both ends are consistent.
Code 11 barcode data does not have to contain check characters. If there is a check character, it can be the last 1 or 2 characters of the data. The check character is a value calculated based on all data to verify whether the data is correct.
Therefore, set to "Disable" and the scanner will transmit all barcode data normally.
[Prohibited]
Scan the following barcode to configure [Prohibited].
**??ne bit check, MOD11??
Scan the following barcode to configure **[One digit verification, MOD11].
[Two-digit checksum, MOD11/MOD11]
Scan the following barcode to configure [two-digit verification, MOD11/MOD11].
[Two-digit checksum, MOD11/MOD9]
Scan the following barcode to configure [two-digit verification, MOD11/MOD9].
[MOD11 single verification (Len<=10)
Scan the following barcode to configure [MOD11 single verification (Len<=10).
MOD11/MOD11 double verification (Len>10)]
[MOD11 single verification (Len<=10)
Scan the following barcode to configure [MOD11 single verification (Len<=10).
MOD11/MOD9 double verification (Len>10)]
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.