This article introduces the setting method of "command trigger mode", which is suitable for finding the corresponding configuration barcode and completing parameter adjustment.
Applicable to:
A5, A6, A8, CN-40, D-8600, NT-2050, NT-2055M, NT-2085 Pro, C850, E800, R2L, RS-8000BT, RS-8000PT, CS7501, NT-1950
Questions
- How to set command trigger mode?
- Where is the command trigger mode configuration barcode?
- How to adjust the command trigger mode parameters?
Resolution / Answer
This setting controls when the device starts scanning, how long it lasts, and how continuous scans are handled. It is usually adjusted when manual triggering, automatic sensing, avoiding repeated output or improving scanning response speed are required.
The reading module is triggered by commands to read, and the reading can be actively ended through commands. If the reading is successful or the reading time exceeds the single reading time, the reading will end.
[Note] Trigger and end commands are valid in any mode
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.