This article explains how to configure the "Decode Success Beep Volume" and is intended for locating the corresponding configuration barcode and adjusting the parameter.
Applicable to:
CS9000, RD1900, NT-1988, NT-12895
Questions
- How to set the sound volume for successful decoding?
- Where is the code for setting the sound volume of the successful decoding sound?
- How to adjust the volume parameters of the successful decoding sound?
Resolution / Answer
This setting controls the device's sound, lighting, aiming, or image-related feedback. It is usually used when you need to reduce the beep sound, confirm the scanning status, improve lighting positioning, or adjust the image reading effect.
Modify the beep volume after successful decoding. Default = high.
(8410091.) Low
Scan the following barcode, (8410091.) Low.
(8410092.) Medium
Scan the following barcode, (8410092.).
(8410093.) * High
Scan the following barcode, (8410093.) * High.
(8410090.) Close
Scan the following barcode, (8410090.) to close.
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.