This article explains how to configure "Command Parsing" and is intended for locating the corresponding configuration barcode and adjusting the parameter.
Applicable to:
C740, E740, F1900, F20, K6, L3, L6BL, L3S, L6BLS, L6S, NT-2100, R3L, S3, S6, H3, M20, NT-1228BC, W6, W6-X, Z3S
Questions
- How to set up command parsing?
- Where is the command parsing configuration barcode?
- How to adjust the command parsing parameters?
Resolution / Answer
This article introduces the purpose and configuration method of "command parsing". Usually refer to this article when you need to change the default behavior of the device, adapt to the business system, or find the corresponding configuration barcode.
When CMD=0x01, it means control command.
DA0=0x01, control scanner switch command, can control the scanner to open or close the decoding function
DA1=0x00, control the scanner to turn off (turn off decoding)
DA1=0x01, controls the scanner to turn on (turn on decoding, no timeout, that is, it stays on when there is no decoding, until the decoding is completed.)
DA1=0x02, control the scanner to open (enable decoding, there is a timeout)
DA2~DA3, timeout time, unit is 1ms (format is 0xDA3 0xDA2)
When CMD=0x02, it means setting command
DA0, indicates the effective byte length of the configuration barcode + 1 (for example, the version number configuration barcode displayed is 000A0, the length is 5, DA0=6)
DA1, fixed to 0x82
DA2~DA11, configuration barcode content (set barcode encoding), DA2 starts to fill in 0x00 for insufficient bits
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.