This article introduces the setting method of "image stabilization duration", which is suitable for finding the corresponding configuration barcode and completing parameter adjustment.
Applicable to:
A5, A6, A8, CN-40, D-8600, NT-2050, NT-2055M, NT-2085 Pro, C850, E800, R2L, RS-8000BT, RS-8000PT, CS7501, NT-1950
Questions
- How to set the image stabilization duration?
- Where is the code for setting the image stabilization duration?
- How to adjust the image stabilization duration parameter?
Resolution / Answer
This article introduces the use and configuration method of "image stabilization duration". Usually refer to this article when you need to change the default behavior of the device, adapt to the business system, or find the corresponding configuration barcode.
The image stabilization time refers to the time that the reading module that detects scene changes in the sensor decode mode needs to wait for the image to stabilize before reading the code. The image stabilization time setting range is: 0-65535ms, and the default value is: 300ms.
a) Scan the "Stabilization Duration" configuration barcode
Stable image duration
Scan the following barcode to determine the image stabilization duration.
b) Scan the "Digital Setup Code". For example, if the duration is 100ms, scan 1, 0, 0; if the duration is 1005ms, scan 1, 0, 0, 5
c) Scan the "OK" configuration barcode to end the setting
OK
Scan the following barcode to confirm.
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.