This article introduces the setting method of "Decoding Tone Frequency", which is suitable for finding the corresponding configuration barcode and completing parameter adjustment.
Applicable to:
A5, A6, A8, CN-40, D-8600, NT-2050, NT-2055M, NT-2085 Pro, C850, E800, R2L, RS-8000BT, RS-8000PT, CS7501, NT-1950
Questions
- How to set the decoding prompt tone frequency?
- Where is the decoding tone frequency configuration barcode?
- How to adjust the decoding prompt audio frequency parameters?
Resolution / Answer
This setting controls the device's sound, lighting, aiming, or image-related feedback. It is usually used when you need to reduce the beep sound, confirm the scanning status, improve lighting positioning, or adjust the image reading effect.
The resonant frequency of the buzzer used by the user may be different from the default frequency. You can adjust the frequency of the decoding prompt tone by reading the following configuration barcode. Default is 2700Hz.
a) Scan the "Buzzer Frequency" configuration barcode
Buzzer frequency
Please scan the corresponding barcode and buzzer frequency below.
b) Scan the "Digital Setup Code". For example, if the frequency is 1500Hz, sweep 1, 5, 0, 0; if the frequency is 2700Hz, sweep 2, 7, 0, 0
c) Scan the "OK" configuration barcode to end the setting
OK
Scan the following barcode to confirm.
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.