This article introduces the setting method of "NEC25 check digit transmission", which is suitable for finding the corresponding configuration barcode and completing parameter adjustment.
Applicable to:
A5, A6, A8, CN-40, D-8600, NT-2050, NT-2055M, NT-2085 Pro, C850, E800, R2L, RS-8000BT, RS-8000PT, CS7501, NT-1950
Questions
- How to set up NEC25 check digit transmission?
- Where is the NEC25 check digit transmission configuration barcode?
- How to adjust the NEC25 check digit transmission parameters?
Resolution / Answer
This setting is used to configure the communication method or communication parameters between the device and the host. Usually when connecting to a computer, serial device, RS485/Modbus network or access control Wiegand system, you need to ensure that the parameters at both ends are consistent.
Read the following configuration barcode to set whether the NEC25 check digit is transmitted.
[Note] To enable transmission of check digits, please enable the check digit verification function first.
*Disabled Enabled
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.