This article introduces the setting method of "single scan time (scan duration)", which is suitable for scenarios where you need to adjust the parameters related to "trigger mode" or scan the corresponding configuration barcode.
Applicable to:
F16, F18W, K20, K28, L5, L5S, L8, L8BL, L8BLS, L8S, M60, M80, NT-1228BL, S5, S8, Z2S, C750, W22, W28, DS8100, DS2800, DS7500, DS8500, H8, M5, M5S, M8BT, M8BTS, NT-91
Questions
- How to set the single scan time (scan duration)?
- Where is the configuration barcode for the single scan time (scan duration)?
- How to adjust the single scan time (scan duration) parameter?
Resolution / Answer
This setting controls when the device starts scanning, how long it lasts, and how continuous scans are handled. It is usually adjusted when manual triggering, automatic sensing, avoiding repeated output or improving scanning response speed are required.
This parameter setting customizes the maximum duration of a single scan. Scan the barcode below first. Next, scan the 3-digit configuration barcode in the appendix to set the corresponding required time. If there are less than 3 digits, fill them with 0s.
Default: 3000ms, unit: 100ms, range: 500-25500ms
For example:
Set the scan duration of 500ms, scan the barcode below, and then scan the numeric configuration barcodes of "0", "0", and "5"; set the scan duration of 10500ms, scan the barcode below, and then scan the barcodes of "1", "0", and "5". To change a selection or cancel an incorrect setting, scan the "Cancel Barcode" in the appendix.
Scan duration (default: 3 seconds)
Scan the following barcode for the scan duration (default: 3 seconds).
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.