This article introduces the setting method of "Continuous Reading Interval", which is suitable for scenarios where you need to adjust the relevant parameters of "Trigger Mode" or scan the corresponding configuration barcode.
Applicable to:
F16, F18W, K20, K28, L5, L5S, L8, L8BL, L8BLS, L8S, M60, M80, NT-1228BL, S5, S8, Z2S, C750, W22, W28, DS8100, DS2800, DS7500, DS8500, H8, M5, M5S, M8BT, M8BTS, NT-91
Questions
- How to set the continuous reading interval?
- Where is the continuous reading interval configuration barcode?
- How to adjust the continuous reading interval parameter?
Resolution / Answer
This setting controls when the device starts scanning, how long it lasts, and how continuous scans are handled. It is usually adjusted when manual triggering, automatic sensing, avoiding repeated output or improving scanning response speed are required.
The interval between two readings in continuous mode. Regardless of whether the last reading was successful or failed, it will automatically enter the next reading after this time. To set the continuous reading interval, scan the barcode below. Next scan the 2-digit setup code in the appendix to correspond to the desired timeout. The missing bits are filled with 0s.
Default: 500ms, unit: 100ms, range: 0-9900ms
For example, to set a timeout of 0.5 seconds, scan the barcode below, then scan the "0" and "5" barcodes. To change selections or cancel incorrect input settings, scan the "Cancel barcode" in the appendix.
Continuous reading interval (default: 500ms.)
Scan the following barcode for continuous reading interval (default: 500ms.).
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.