This article introduces the setting method of "Continue Scanning", which is suitable for scenarios where you need to adjust the parameters related to "Trigger Mode" or scan the corresponding configuration barcode.
Applicable to:
F16, F18W, K20, K28, L5, L5S, L8, L8BL, L8BLS, L8S, M60, M80, NT-1228BL, S5, S8, Z2S, C750, W22, W28, DS8100, DS2800, DS7500, DS8500, H8, M5, M5S, M8BT, M8BTS, NT-91
Questions
- How to set up QR code scanning?
- Continue to scan the QR code to set up where is the code?
- How to adjust the parameters for continuing to scan the code?
Resolution / Answer
This setting controls when the device starts scanning, how long it lasts, and how continuous scans are handled. It is usually adjusted when manual triggering, automatic sensing, avoiding repeated output or improving scanning response speed are required.
This function is applicable to the triggering modes: (level) key hold, (pulse) single key trigger, and host mode. In the continuous code scanning mode, the continuous reading interval and the same code delay are valid.
Prohibited from continuing to scan the QR code
Scan the following barcode. Further scanning will be prohibited.
Enable continued scanning
Scan the following barcode to enable continued scanning.
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.