This article introduces the setting method of "Do not output the same code in a single round of decoding", which is suitable for scenarios where you need to adjust the relevant parameters of the "trigger mode" or scan the corresponding configuration barcode.
Applicable to:
F16, F18W, K20, K28, L5, L5S, L8, L8BL, L8BLS, L8S, M60, M80, NT-1228BL, S5, S8, Z2S, C750, W22, W28, DS8100, DS2800, DS7500, DS8500, H8, M5, M5S, M8BT, M8BTS, NT-91
Questions
- How to set the same code in a single round of decoding not to be output?
- Where is the configuration barcode for not outputting the same code in a single round of decoding?
- How to adjust the parameters when the same code is not output in a single round of decoding?
Resolution / Answer
This setting controls when the device starts scanning, how long it lasts, and how continuous scans are handled. It is usually adjusted when manual triggering, automatic sensing, avoiding repeated output or improving scanning response speed are required.
Within one round of decoding, the same code will not be output, and a maximum of 20 historical records of different decoding results will be cached. This function is suitable for "continuous key press", "continue scanning code" and other modes.
Example:
Key press continuous mode: When the key is pressed, a round of decoding begins until the key is pressed again to exit the continuous decoding mode. There is a round of decoding process between two key presses (note that it is different from a single scan).
Continue scanning code + key hold/host mode: scanning code ends due to timeout in the middle, and does not end as a round.
Disable the same code in a single round of decoding from being output.
Scan the following barcode to configure which will prohibit the output of the same code within a single round of decoding.
Enable the same code in a single round of decoding not to be output
Scan the following barcode to enable single-round decoding without outputting the same code.
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.