This article introduces the setting method of "USPS Postnet Check Digit Transmission", which is suitable for finding the corresponding configuration barcode and completing parameter adjustment.
Applicable to:
A5, A6, A8, CN-40, D-8600, NT-2050, NT-2055M, NT-2085 Pro, C850, E800, R2L, RS-8000BT, RS-8000PT, CS7501, NT-1950
Questions
- How to set up USPS Postnet check digit transmission?
- Where is the USPS Postnet Check Digit Transmission Setup Code?
- How to adjust the USPS Postnet check digit transmission parameters?
Resolution / Answer
This setting is used to configure the communication method or communication parameters between the device and the host. Usually when connecting to a computer, serial device, RS485/Modbus network or access control Wiegand system, you need to ensure that the parameters at both ends are consistent.
Read the following configuration barcode to enable/disable transmission of the USPS Postnet check digit.
Disabled *Enabled
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.