This article introduces the setting method of "Stable Sensing Time", which is suitable for scenarios where you need to adjust the relevant parameters of "Trigger Mode" or scan the corresponding configuration barcode.
Applicable to:
F16, F18W, K20, K28, L5, L5S, L8, L8BL, L8BLS, L8S, M60, M80, NT-1228BL, S5, S8, Z2S, C750, W22, W28, DS8100, DS2800, DS7500, DS8500, H8, M5, M5S, M8BT, M8BTS, NT-91
Questions
- How to set the stable sensing time?
- Where is the stable sensing time configuration barcode?
- How to adjust the stable sensing time parameters?
Resolution / Answer
This setting controls when the device starts scanning, how long it lasts, and how continuous scans are handled. It is usually adjusted when manual triggering, automatic sensing, avoiding repeated output or improving scanning response speed are required.
To set the stable time before the automatic sensing mode enters the detection environment, first Scan the following barcode to configure and then scan the 2-digit configuration barcode in the appendix to set the corresponding required time. Less than 2 digits are padded with 0s. Default: 500ms, unit: 100ms, range: 0-9900ms. For example: set the stable sensing time to 200ms. Scan the stable sensing time configuration barcode first, then scan the digital configuration barcodes 0 and 2. Set the stable sensing time to 1500ms. Scan the stable sensing time configuration barcode first, and then scan the digital configuration barcodes 1 and 5.
Stable sensing time
Scan the following barcode to stabilize the sensing time.
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.