This article introduces the setting method of "data bits", which is suitable for scenarios where you need to adjust the parameters related to "communication method/serial parameters" or scan the corresponding configuration barcode.
Applicable to:
F16, F18W, K20, K28, L5, L5S, L8, L8BL, L8BLS, L8S, M60, M80, NT-1228BL, S5, S8, Z2S, C750, W22, W28, DS8100, DS2800, DS7500, DS8500, H8, M5, M5S, M8BT, M8BTS, NT-91
Questions
- How to set data bits?
- Where is the data bit configuration barcode?
- How to adjust the data bit parameters?
Resolution / Answer
This setting is used to configure the communication method or communication parameters between the device and the host. Usually when connecting to a computer, serial device, RS485/Modbus network or access control Wiegand system, you need to ensure that the parameters at both ends are consistent.
Data bits: This is a measure of the actual data bits in communication.
Data bits 7 bits
Scan the following barcode to configure the data is 7 digits long.
Data bits 8 bits
Scan the following barcode to configure the data is 8 digits long.
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.