This article introduces the setting method of "485 device slave address modification", which is suitable for scenarios where you need to adjust the relevant parameters of "communication method/RS485 networking function" or scan the corresponding configuration barcode.
Applicable to:
F16, F18W, K20, K28, L5, L5S, L8, L8BL, L8BLS, L8S, M60, M80, NT-1228BL, S5, S8, Z2S, C750, W22, W28, DS8100, DS2800, DS7500, DS8500, H8, M5, M5S, M8BT, M8BTS, NT-91
Questions
- How to modify the slave address of 485 device?
- What are the steps to modify the secondary address of 485 device?
- Where is the slave address configuration barcode of the 485 device?
Resolution / Answer
This article introduces the use and configuration method of "485 device slave address". Usually refer to this article when you need to change the default behavior of the device, adapt to the business system, or find the corresponding configuration barcode.
Set 485 slave address
Make setup code ^380811xxxx
From address 0001
Scan the following barcode, from address 0001.
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.