This article introduces the setting method of "RS485 networking decoding data format", which is suitable for scenarios where you need to adjust the relevant parameters of "communication method/RS485 networking function" or scan the corresponding configuration barcode.
Applicable to:
F16, F18W, K20, K28, L5, L5S, L8, L8BL, L8BLS, L8S, M60, M80, NT-1228BL, S5, S8, Z2S, C750, W22, W28, DS8100, DS2800, DS7500, DS8500, H8, M5, M5S, M8BT, M8BTS, NT-91
Questions
- How to set the RS485 network decoding data format?
- Where is the RS485 network decoding data format configuration barcode?
- How to adjust the RS485 network decoding data format parameters?
Resolution / Answer
This setting is used to configure the communication method or communication parameters between the device and the host. Usually when connecting to a computer, serial device, RS485/Modbus network or access control Wiegand system, you need to ensure that the parameters at both ends are consistent.
It is forbidden to send decoded data directly in the format of add+data. When using RS485 networking, the data packet format must be set to original data when the se955 packet format is forbidden.
Disable RS485 networking decoding data format
Scan the following barcode to disable RS485 networking decoding data format.
Enable RS485 networking decoding data format
Scan the following barcode to enable the RS485 network decoding data format.
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.