This article introduces the setting method of "Save RS485 networking decoded data to cache", which is suitable for scenarios where you need to adjust the relevant parameters of "Communication method/RS485 networking function" or scan the corresponding configuration barcode.
Applicable to:
F16, F18W, K20, K28, L5, L5S, L8, L8BL, L8BLS, L8S, M60, M80, NT-1228BL, S5, S8, Z2S, C750, W22, W28, DS8100, DS2800, DS7500, DS8500, H8, M5, M5S, M8BT, M8BTS, NT-91
Questions
- How to set up RS485 networking decoding data to be saved in cache?
- Where is the configuration barcode for saving RS485 network decoding data to cache?
- How to adjust the parameters for saving RS485 network decoding data to cache?
Resolution / Answer
This setting is used to configure the communication method or communication parameters between the device and the host. Usually when connecting to a computer, serial device, RS485/Modbus network or access control Wiegand system, you need to ensure that the parameters at both ends are consistent.
The RS485 networking decoded data is not sent, but is saved in the cache and sent once when waiting for the host computer to query. The RS485 networking data packet format must be turned on to take effect.
Disable RS485 networking decoding data from being saved in cache
Scan the following barcode to save the RS485 networking decoding data to the cache.
Enable RS485 networking decoding data to be saved in cache
Scan the following barcode to enable the RS485 networking decoding data to be saved to the cache.
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.