This article introduces the setting method of "Slave Station Address Quick Setting", which is suitable for scenarios where you need to adjust the relevant parameters of "Communication Mode/Modbus Rtu Networking Function" or scan the corresponding configuration barcode.
Applicable to:
F16, F18W, K20, K28, L5, L5S, L8, L8BL, L8BLS, L8S, M60, M80, NT-1228BL, S5, S8, Z2S, C750, W22, W28, DS8100, DS2800, DS7500, DS8500, H8, M5, M5S, M8BT, M8BTS, NT-91
Questions
- How to quickly set the slave address?
- Is there a quick configuration barcode for the slave station address?
- How to set the slave address without entering parameters?
Resolution / Answer
This setting is used to configure the communication method or communication parameters between the device and the host. Usually when connecting to a computer, serial device, RS485/Modbus network or access control Wiegand system, you need to ensure that the parameters at both ends are consistent.
Note: The factory default slave address is 0x00. Customers need to configure it to other addresses (1-255) before they can be used.
Address 0x00
Scan the following barcode, address 0x00.
Address 0x01
Scan the following barcode, address 0x01.
Address 0x02
Scan the following barcode, address 0x02.
Address 0x03
Scan the following barcode, address 0x03.
Address 0xAA
Scan the following barcode, address 0xAA.
Address 0xBB
Scan the following barcode, address 0xBB.
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.