This article introduces the setting method of "Enter Setup Code Password", which is suitable for scenarios where you need to adjust the relevant parameters of "Setup Code Password Mode" or scan the corresponding configuration barcode.
Applicable to:
F16, F18W, K20, K28, L5, L5S, L8, L8BL, L8BLS, L8S, M60, M80, NT-1228BL, S5, S8, Z2S, C750, W22, W28, DS8100, DS2800, DS7500, DS8500, H8, M5, M5S, M8BT, M8BTS, NT-91
Questions
- How to enter the setup code password?
- What are the steps to enter the setup code password?
- How to set up code and password verification?
Resolution / Answer
This setting is used to manage and configure barcode scanning permissions, sending methods, or password protection. It is usually used when you need to prevent accidentally scanning the setup code, lock parameters, or quickly configure the device through the setup code.
Password is 2 digits, from 0-9.
Enter the setup code password: After you enter the correct password in the setup code password mode, the device will be unlocked and allow the device to perform general setup code operations. Scan the following barcode to configure then scan the 2-digit setup code in the appendix corresponding to the required password. If there are less than 2 digits, fill them with 0s.
For example, to enter password 68, scan the barcode below, then scan "6" and "8". To change a selection or cancel an incorrect setting, scan the "Cancel Barcode" in the appendix.
Enter the setup code password
Scan the following barcode to enter the setup code password.
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.