This article introduces the setting method of "Trigger Reading Event", which is suitable for scenarios where you need to adjust the relevant parameters of "Event Report" or scan the corresponding configuration barcode.
Applicable to:
F16, F18W, K20, K28, L5, L5S, L8, L8BL, L8BLS, L8S, M60, M80, NT-1228BL, S5, S8, Z2S, C750, W22, W28, DS8100, DS2800, DS7500, DS8500, H8, M5, M5S, M8BT, M8BTS, NT-91
Questions
- How to set up a trigger reading event?
- Where is the configuration barcode for triggering the reading event?
- How to adjust the parameters for triggering reading events?
Resolution / Answer
This setting controls when the device starts scanning, how long it lasts, and how continuous scans are handled. It is usually adjusted when manual triggering, automatic sensing, avoiding repeated output or improving scanning response speed are required.
When the scan engine triggers reading, it can prompt through instructions or GPIO pins. The GPIO pin prompt remains low until the reading is completed.
Disable triggering of reading events
Scan the following barcode to disable triggering of reading events.
Event enable
Scan the following barcode to enable the event.
Pin event enable
Scan the following barcode to enable pin events.
Event and GPIO pin enable
Scan the following barcode to enable event and GPIO pins.
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.