This article introduces the setting method of "Transmit UPC-A check digit", which is suitable for scenarios where you need to adjust "UPC-A" related parameters or scan the corresponding configuration barcode.
Applicable to:
F16, F18W, K20, K28, L5, L5S, L8, L8BL, L8BLS, L8S, M60, M80, NT-1228BL, S5, S8, Z2S, C750, W22, W28, DS8100, DS2800, DS7500, DS8500, H8, M5, M5S, M8BT, M8BTS, NT-91
Questions
- How to set transmission UPC-A check digit?
- Where is the transmit UPC-A check digit configuration barcode?
- How to adjust the transmission UPC-A check digit parameters?
Resolution / Answer
This setting is used to configure the communication method or communication parameters between the device and the host. Usually when connecting to a computer, serial device, RS485/Modbus network or access control Wiegand system, you need to ensure that the parameters at both ends are consistent.
Scan the corresponding barcode below to set whether to transmit the UPC-A check code.
Transmit UPC-A check digit
Scan the following barcode to transmit the UPC-A check digit.
Do not transmit UPC-A check digit
Scan the following barcode to the UPC-A check digit will not be transmitted.
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.