This article introduces the setting method of "Modify Setup Code Password", which is suitable for scenarios where you need to adjust the relevant parameters of "Setup Code Password Mode" or scan the corresponding configuration barcode.
Applicable to:
F16, F18W, K20, K28, L5, L5S, L8, L8BL, L8BLS, L8S, M60, M80, NT-1228BL, S5, S8, Z2S, C750, W22, W28, DS8100, DS2800, DS7500, DS8500, H8, M5, M5S, M8BT, M8BTS, NT-91
Questions
- How to change the setup code password?
- What are the steps to change the setup code password?
- Setting Code Password Where is the configuration barcode?
Resolution / Answer
This setting is used to manage and configure barcode scanning permissions, sending methods, or password protection. It is usually used when you need to prevent accidentally scanning the setup code, lock parameters, or quickly configure the device through the setup code.
You can change the password of the setup code only when the setup code password mode is enabled and the password verification is passed (the device is unlocked).
To modify the setup code password, scan the following barcode. Next, scan the 2-digit configuration barcode in the appendix to correspond to the new password. If there are less than 2 digits, fill them with 0s. For example, the new password is 96, scan the barcode below, then scan "9" and "6". To change a selection or cancel an incorrect setting, scan the "Cancel Barcode" in the appendix.
Modify the configuration barcode password
Scan the following barcode to modify the setup code password.
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.