This article introduces the setting method of "EAN-8 Send Check Digit", which is suitable for scenarios where you need to adjust "EAN-8" related parameters or scan the corresponding configuration barcode.
Applicable to:
F16, F18W, K20, K28, L5, L5S, L8, L8BL, L8BLS, L8S, M60, M80, NT-1228BL, S5, S8, Z2S, C750, W22, W28, DS8100, DS2800, DS7500, DS8500, H8, M5, M5S, M8BT, M8BTS, NT-91
Questions
- How to set up EAN-8 to send check digit?
- Where is the EAN-8 transmission check digit configuration barcode?
- How to adjust the EAN-8 sending parity digit parameters?
Resolution / Answer
This setting is used to configure the communication method or communication parameters between the device and the host. Usually when connecting to a computer, serial device, RS485/Modbus network or access control Wiegand system, you need to ensure that the parameters at both ends are consistent.
Disable EAN-8 from sending check digits
Scan the following barcode to disable EAN-8 from sending check digits.
Enable EAN-8 to send check digits
Scan the following barcode to enable EAN-8 to send check digits.
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.