This article introduces the setting method of "Code 128 Send Check Character", which is suitable for scenarios where you need to adjust "Code 128" related parameters or scan the corresponding configuration barcode.
Applicable to:
F16, F18W, K20, K28, L5, L5S, L8, L8BL, L8BLS, L8S, M60, M80, NT-1228BL, S5, S8, Z2S, C750, W22, W28, DS8100, DS2800, DS7500, DS8500, H8, M5, M5S, M8BT, M8BTS, NT-91
Questions
- How to set Code 128 to send check characters?
- Code 128 Where is the configuration barcode for sending check characters?
- Code 128 How to adjust the parameters for sending verification characters?
Resolution / Answer
This setting is used to configure the communication method or communication parameters between the device and the host. Usually when connecting to a computer, serial device, RS485/Modbus network or access control Wiegand system, you need to ensure that the parameters at both ends are consistent.
Enable Code 128 to send check characters
Scan the following barcode to enable Code 128 to send check characters.
Disable Code 128 from sending check characters
Scan the following barcode to disable Code 128 from sending check characters.
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.