This article introduces the setting method of "UCC/EAN-128 Send Check Character", which is suitable for scenarios where you need to adjust the relevant parameters of "GS1-128 (formerly UCC/EAN-128)" or scan the corresponding configuration barcode.
Applicable to:
F16, F18W, K20, K28, L5, L5S, L8, L8BL, L8BLS, L8S, M60, M80, NT-1228BL, S5, S8, Z2S, C750, W22, W28, DS8100, DS2800, DS7500, DS8500, H8, M5, M5S, M8BT, M8BTS, NT-91
Questions
- How to set up UCC/EAN-128 to send check characters?
- Where is the UCC/EAN-128 sending check character configuration barcode?
- How to adjust UCC/EAN-128 sending check character parameters?
Resolution / Answer
This setting is used to configure the communication method or communication parameters between the device and the host. Usually when connecting to a computer, serial device, RS485/Modbus network or access control Wiegand system, you need to ensure that the parameters at both ends are consistent.
Enable UCC/EAN-128 to send check characters
Scan the following barcode to enable UCC/EAN-128 to send check characters.
Disable UCC/EAN-128 from sending check characters
Scan the following barcode to disable UCC/EAN-128 from sending check characters.
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.