This article introduces the setting method of "Codabar Send Verification Characters", which is suitable for scenarios where you need to adjust "Codabar" related parameters or scan the corresponding configuration barcode.
Applicable to:
F16, F18W, K20, K28, L5, L5S, L8, L8BL, L8BLS, L8S, M60, M80, NT-1228BL, S5, S8, Z2S, C750, W22, W28, DS8100, DS2800, DS7500, DS8500, H8, M5, M5S, M8BT, M8BTS, NT-91
Questions
- How to set up Codabar to send check characters?
- Where is the verification character configuration barcode sent by Codabar?
- How to adjust the verification character parameters sent by Codabar?
Resolution / Answer
This setting is used to configure the communication method or communication parameters between the device and the host. Usually when connecting to a computer, serial device, RS485/Modbus network or access control Wiegand system, you need to ensure that the parameters at both ends are consistent.
Enable Codabar to send check characters
Scan the following barcode to enable Codabar to send verification characters.
Disable Codabar from sending check characters
Scan the following barcode to disable Codabar from sending check characters.
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.