This article introduces the setting method of "Data Matrix ECI Control", which is suitable for scenarios where you need to adjust the relevant parameters of "Data Matrix (DM)" or scan the corresponding configuration barcode.
Applicable to:
F16, F18W, K20, K28, L5, L5S, L8, L8BL, L8BLS, L8S, M60, M80, NT-1228BL, S5, S8, Z2S, C750, W22, W28, DS8100, DS2800, DS7500, DS8500, H8, M5, M5S, M8BT, M8BTS, NT-91
Questions
- How to control Data Matrix ECI?
- How to turn Data Matrix ECI on or off?
- Where is the Data Matrix ECI control configuration barcode?
Resolution / Answer
This setting is used to control the reading, verification, length or output rules of the specified barcode type. It is usually used when certain types of barcodes cannot be scanned, the misreading rate is high, or when it is necessary to limit the reading of barcodes in specific formats.
ECI does not output
Scan the following barcode to configure ECI will not be output.
ECI output
Scan the following barcode for ECI output.
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.