This article introduces the setting method of "EAN 13", which is suitable for finding the corresponding configuration barcode and completing parameter adjustment.
Applicable to:
C990, I5, I8, W8-WIFI, W8-X, W9, W9S, NT-1202, NT-1202W, CS8501, GY-20U, GY-30U, GY-50U, GY-60U, NT-90
Questions
- How to set up EAN 13?
- Where is the EAN 13 setup code?
- How to adjust EAN 13 parameters?
Resolution / Answer
This setting is used to control the reading, verification, length or output rules of the specified barcode type. It is usually used when certain types of barcodes cannot be scanned, the misreading rate is high, or when it is necessary to limit the reading of barcodes in specific formats.
**EAN 13**
**Start Setup**
Enable EAN 13 (default)
Close EAN 13
**END SETTING**
**EAN 13**
**Start Setup**
Transmit check digit (default)
No check digits transmitted
**END SETTING**
**EAN 13**
**Start Setup**
Enable ISBN conversion
Turn off ISBN conversion (default)
**END SETTING**
**EAN 13**
**Start Setup**
Enable ISSN conversion
Turn off ISSN conversion (default)
**END SETTING**
**EAN** **13**
**Start Setup**
Enable EAN 13 2/5 digit add-on code
Turn off EAN 13 2/5 digit add-on code (default)
**END SETTING**
**EAN** **13**
**Start Setup**
Read only EAN 13 2/5 digit add-on code
Read EAN 13 and EAN 13 2/5 digit add-on code (default)
**END SETTING**
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.