This article introduces the setting method of "Code 11", which is suitable for finding the corresponding configuration barcode and completing parameter adjustment.
Applicable to:
C990, I5, I8, W8-WIFI, W8-X, W9, W9S, NT-1202, NT-1202W, CS8501, GY-20U, GY-30U, GY-50U, GY-60U, NT-90
Questions
- How to set up Code 11?
- Where is the Code 11 setup code?
- How to adjust the parameters of Code 11?
Resolution / Answer
This setting is used to control the reading, verification, length or output rules of the specified barcode type. It is usually used when certain types of barcodes cannot be scanned, the misreading rate is high, or when it is necessary to limit the reading of barcodes in specific formats.
**Code 11**
**Start Setup**
Enable Code 11
Turn off Code 11 (default)
**END SETTING**
**Code 11**
**Start Setup**
Transmit check digit (default)
No check digits transmitted
**END SETTING**
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.