This article introduces the setting method of "Codabar", which is suitable for finding the corresponding configuration barcode and completing parameter adjustment.
Applicable to:
C990, I5, I8, W8-WIFI, W8-X, W9, W9S, NT-1202, NT-1202W, CS8501, GY-20U, GY-30U, GY-50U, GY-60U, NT-90
Questions
- How to set up Codabar?
- Where is the Codabar setup code?
- How to adjust Codabar parameters?
Resolution / Answer
This setting is used to control the reading, verification, length or output rules of the specified barcode type. It is usually used when certain types of barcodes cannot be scanned, the misreading rate is high, or when it is necessary to limit the reading of barcodes in specific formats.
**Codabar**
**Start Setup**
Enable Codabar (default)
Close Codabar
**END SETTING**
**Codabar**
**Start Setup**
No verification (default)
Verify and transmit Verify but do not transmit
**END SETTING**
**Codabar**
**Start Setup**
Transmission start/suffix terminator
Do not transmit start/stop characters (default)
**END SETTING**
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.