This article introduces the setting method of "turn on the aiming light", which is suitable for finding the corresponding configuration barcode and completing parameter adjustment.
Applicable to:
E900
Questions
- How to set up the aiming light?
- Where is the configuration barcode for turning on the aiming light?
- How to adjust the parameters for lighting the aiming light?
Resolution / Answer
This setting controls the device's sound, lighting, aiming, or image-related feedback. It is usually used when you need to reduce the beep sound, confirm the scanning status, improve lighting positioning, or adjust the image reading effect.
Leave the scanner's aiming light on for a while. When executing this command, the scanner will not scan and read codes.
The unit is milliseconds and the value range is 10 - 3600000.
Send: LEDONA$ $ represents Data. When Data is '*' or '&', the response is: LEDONA<ACK>; when Data is '^', the response is: LEDONA10-3600000 <ACK>;
Turn on the aiming light for 1 minute:
Send ~<SOH>0000#LEDONA60000;<ETX>
Response <STX> <SOH>0000#LEDONA60000 <ACK>;<ETX>
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.