This article introduces the setting method of "NEC-25(COOP25) Send Check Character", which is suitable for scenarios where you need to adjust "NEC-25(COOP25)" related parameters or scan the corresponding configuration barcode.
Applicable to:
F16, F18W, K20, K28, L5, L5S, L8, L8BL, L8BLS, L8S, M60, M80, NT-1228BL, S5, S8, Z2S, C750, W22, W28, DS8100, DS2800, DS7500, DS8500, H8, M5, M5S, M8BT, M8BTS, NT-91
Questions
- How to set up NEC-25(COOP25) to send check characters?
- Where is the NEC-25 (COOP25) sending check character configuration barcode?
- How to adjust the parameters for sending check characters in NEC-25 (COOP25)?
Resolution / Answer
This setting is used to configure the communication method or communication parameters between the device and the host. Usually when connecting to a computer, serial device, RS485/Modbus network or access control Wiegand system, you need to ensure that the parameters at both ends are consistent.
Enable NEC-25 (COOP25) to send check characters
Scan the following barcode to enable NEC-25 (COOP25) to send check characters.
Disable NEC-25 (COOP25) from sending check characters
Scan the following barcode to disable NEC-25 (COOP25) from sending check characters.
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.