This article introduces the setting method of "Scan Mode", which is suitable for finding the corresponding configuration barcode and completing parameter adjustment.
Applicable to:
C990, I5, I8, W8-WIFI, W8-X, W9, W9S, NT-1202, NT-1202W, CS8501, GY-20U, GY-30U, GY-50U, GY-60U, NT-90
Questions
- How to set scan mode?
- Where is the scan mode configuration barcode?
- How to adjust the scanning mode parameters?
Resolution / Answer
This setting controls when the device starts scanning, how long it lasts, and how continuous scans are handled. It is usually adjusted when manual triggering, automatic sensing, avoiding repeated output or improving scanning response speed are required.
**Level trigger:**
Scan while the scan key is pressed, and end when decoding is completed or the reading time is exceeded.
**Automatic induction:**
Start scanning when the image changes and end when the reading time exceeds
**Continuous Scanning:**
Continuously read single or multiple barcodes (define the decoding sequence through the same code reading interval setting), press and release the scan button to start or end scanning
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.