This article introduces the setting method of "continuous scanning", which is suitable for finding the corresponding configuration barcode and completing parameter adjustment.
Applicable to:
C990, I5, I8, W8-WIFI, W8-X, W9, W9S, NT-1202, NT-1202W, CS8501, GY-20U, GY-30U, GY-50U, GY-60U, NT-90
Questions
- How to set up continuous scanning?
- Where is the continuous scan setup code?
- How to adjust the continuous scanning parameters?
Resolution / Answer
This setting controls when the device starts scanning, how long it lasts, and how continuous scans are handled. It is usually adjusted when manual triggering, automatic sensing, avoiding repeated output or improving scanning response speed are required.
**Continuous Scanning**
**Start Setup**
Continuous Scanning
**END SETTING**
**Same barcode reading**
The same barcode reading method in automatic sensing, continuous scanning, and pulse trigger modes
By default, the same barcode will not be read repeatedly within 500 milliseconds. It can be set from 0 to 5000 milliseconds. 0 means no interval time.
**Restricted Reading** **:**
If the same barcode is read continuously within the time limit, the read barcode will be ignored and not output and the time limit will be re-timed.
time to avoid reading the same code repeatedly.
**Do not output 100** **The same barcode read repeatedly within milliseconds**
Scan "Start Setup"
Scan the "Restricted Reading" configuration barcode
Scan the "Read Time" setup code
Scan the appendix decimal number, "1" configuration barcode
Scan the appendix decimal number, "0" configuration barcode
Scan the appendix decimal number, "0" configuration barcode
Scan "End Setup"
**Interval Read** **:**
If the same barcode is read continuously within the interval, the read barcode will be ignored and not output, but the interval will not be re-timed.
time, if the time exceeds, the barcode will be output.
**Read the same code after one second interval**
Scan "Start Setup"
Scan the "interval read" configuration barcode
Scan the "Read Time" setup code
Scan the appendix decimal number, "1" configuration barcode
Scan the appendix decimal number, "0" configuration barcode
Scan the appendix decimal number, "0" configuration barcode
Scan the appendix decimal number, "0" configuration barcode
Scan "End Setup"
**Do not read the same barcode** **:** Do not read the same barcode repeatedly
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.