This article introduces the setting method of "Supported Barcode System", which is suitable for finding the corresponding configuration barcode and completing parameter adjustment.
Applicable to:
C990, I5, I8, W8-WIFI, W8-X, W9, W9S, NT-1202, NT-1202W, CS8501, GY-20U, GY-30U, GY-50U, GY-60U, NT-90
Questions
- How to set the supported symbology?
- Where is the code to support the code setting?
- How to adjust the supported coding parameters?
Resolution / Answer
This setting is used to control the reading, verification, length or output rules of the specified barcode type. It is usually used when certain types of barcodes cannot be scanned, the misreading rate is high, or when it is necessary to limit the reading of barcodes in specific formats.
**Support encoding**
UPC A On by default
UPC E On by default
EAN 8 Enabled by default
EAN 13 Enabled by default
Code 128 / GS1-128 Enabled by default
Code 39 Enabled by default
Code 93 Enabled by default
Code 32 Close
Code 11 Close
Codabar Enabled by default
Plessey Close
MSI Plessey Enabled by default
Interleaved 2 of 5 Enabled by default
IATA 2 of 5 Close
Matrix 2 of 5 Close
**Support encoding**
Straight 2 of 5 Close
Pharmacode Close
GS1 DataBar 14 Enabled by default
GS1 DataBar 14 Stacked Close
GS1 DataBar Expanded Enabled by default
GS1 DataBar Expanded Stacked Close
GS1 DataBar Limited Enabled by default
Composite Code-A Close
Composite Code-B Close
Composite Code-C Close
PDF417 Enabled by default
Micro PDF417 Enabled by default
Data Matrix Enabled by default
QR Enabled by default
Micro QR Enabled by default
Aztec Close
MaxiCode Close
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.