This article introduces the setting method of "Code 39", which is suitable for finding the corresponding configuration barcode and completing parameter adjustment.
Applicable to:
C990, I5, I8, W8-WIFI, W8-X, W9, W9S, NT-1202, NT-1202W, CS8501, GY-20U, GY-30U, GY-50U, GY-60U, NT-90
Questions
- How to set up Code 39?
- Where is the Code 39 setup code?
- How to adjust the parameters of Code 39?
Resolution / Answer
This setting is used to control the reading, verification, length or output rules of the specified barcode type. It is usually used when certain types of barcodes cannot be scanned, the misreading rate is high, or when it is necessary to limit the reading of barcodes in specific formats.
**Code 39**
**Start Setup**
Enable Code 39 (default)
Close Code 39
**END SETTING**
**Code 39**
**Start Setup**
Enable Code 39 Full ASCII function
Turn off Code 39 Full ASCII function (default)
**END SETTING**
**Code 39**
**Start Setup**
Transmission start/suffix terminator
Do not transmit start/stop characters (default)
**END SETTING**
**Code 39**
**Start Setup**
No verification (default)
Verify and transmit Verify but do not transmit
**END SETTING**
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.