This article introduces the setting method of "GS1 DataBar Limited", which is suitable for finding the corresponding configuration barcode and completing parameter adjustment.
Applicable to:
C990, I5, I8, W8-WIFI, W8-X, W9, W9S, NT-1202, NT-1202W, CS8501, GY-20U, GY-30U, GY-50U, GY-60U, NT-90
Questions
- How to set up GS1 DataBar Limited?
- Where is the GS1 DataBar Limited setup code?
- How to adjust the parameters of GS1 DataBar Limited?
Resolution / Answer
This setting is used to control the additional characters and output mode at the end of the scanned data or during the output process. It is usually used when you need to automatically wrap lines, jump to the next input box, or adjust the data output format after scanning the QR code.
**GS1 DataBar Limited**
**Start Setup**
Enable GS1 DataBar Limited (default)
Close GS1 DataBar Limited
**END SETTING**
**GS1 DataBar Limited**
**Start Setup**
Output AI (01) characters (default)
Do not output AI (01) characters
**END SETTING**
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.