This article introduces the setting method of "Aztec", which is suitable for finding the corresponding configuration barcode and completing parameter adjustment.
Applicable to:
C990, I5, I8, W8-WIFI, W8-X, W9, W9S, NT-1202, NT-1202W, CS8501, GY-20U, GY-30U, GY-50U, GY-60U, NT-90
Questions
- How to set up Aztec?
- Where is the Aztec setup code?
- How to adjust Aztec parameters?
Resolution / Answer
This setting is used to control the reading, verification, length or output rules of the specified barcode type. It is usually used when certain types of barcodes cannot be scanned, the misreading rate is high, or when it is necessary to limit the reading of barcodes in specific formats.
**Aztec**
**Start Setup**
Enable Aztec
Turn off Aztec (default)
**END SETTING**
**Aztec**
**Start Setup**
Enable image decoding (default)
Turn off image decoding
**END SETTING**
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.