This article introduces the setting method of "UPC E", which is suitable for finding the corresponding configuration barcode and completing parameter adjustment.
Applicable to:
C990, I5, I8, W8-WIFI, W8-X, W9, W9S, NT-1202, NT-1202W, CS8501, GY-20U, GY-30U, GY-50U, GY-60U, NT-90
Questions
- How to set up UPC E?
- Where is the UPC E setup code?
- How to adjust UPC E parameters?
Resolution / Answer
This setting is used to control the reading, verification, length or output rules of the specified barcode type. It is usually used when certain types of barcodes cannot be scanned, the misreading rate is high, or when it is necessary to limit the reading of barcodes in specific formats.
**UPC E**
**Start Setup**
Enable UPC E (default)
Close UPC A
**END SETTING**
**UPC E**
**Start Setup**
Transmit first (default)
Do not transfer first bit
**END SETTING**
**UPC E**
**Start Setup**
Enable checksums (default)
Turn off checksums
**END SETTING**
**UPC E**
**Start Setup**
Enable UPC A conversion
Turn off UPC A conversion (default)
**END SETTING**
**UPC** **E**
**Start Setup**
Enable UPC E 2/5 digit add-on code
Turn off UPC E 2/5 digit add-on code (default)
**END SETTING**
**UPC** **E**
**Start Setup**
Only read UPC E 2/5 digit additional code
Read UPC E and UPC E 2/5-digit add-on code (default)
**END SETTING**
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.