This article introduces the setting method of "EAN 8", which is suitable for finding the corresponding configuration barcode and completing parameter adjustment.
Applicable to:
C990, I5, I8, W8-WIFI, W8-X, W9, W9S, NT-1202, NT-1202W, CS8501, GY-20U, GY-30U, GY-50U, GY-60U, NT-90
Questions
- How to set up EAN 8?
- Where is the EAN 8 setup code?
- How to adjust EAN 8 parameters?
Resolution / Answer
This setting is used to control the reading, verification, length or output rules of the specified barcode type. It is usually used when certain types of barcodes cannot be scanned, the misreading rate is high, or when it is necessary to limit the reading of barcodes in specific formats.
**EAN 8**
**Start Setup**
Enable EAN 8 (default)
Close EAN 8
**END SETTING**
**EAN 8**
**Start Setup**
Transmit check digit (default)
No check digits transmitted
**END SETTING**
**EAN 8**
**Start Setup**
Enable EAN-13 conversion
Turn off EAN-13 conversion (default)
**END SETTING**
**EAN 8**
**Start Setup**
Enable EAN 8 2/5 digit add-on code
Turn off EAN 8 2/5 digit add-on code (default)
**END SETTING**
**EAN 8**
**Start Setup**
Read only EAN 8 2/5 digit add-on code
Read EAN 8 and EAN 8 2/5 digit add-on code (default)
**END SETTING**
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.