This article introduces the setting method of "Data Matrix", which is suitable for finding the corresponding configuration barcode and completing parameter adjustment.
Applicable to:
C990, I5, I8, W8-WIFI, W8-X, W9, W9S, NT-1202, NT-1202W, CS8501, GY-20U, GY-30U, GY-50U, GY-60U, NT-90
Questions
- How to set up Data Matrix?
- Where is the Data Matrix setup code?
- How to adjust Data Matrix parameters?
Resolution / Answer
This setting is used to control the reading, verification, length or output rules of the specified barcode type. It is usually used when certain types of barcodes cannot be scanned, the misreading rate is high, or when it is necessary to limit the reading of barcodes in specific formats.
**Data Matrix**
**Start Setup**
Enable Data Matrix (default)
Close Data Matrix
**END SETTING**
**Data Matrix**
**Start Setup**
Enable image decoding (default)
Turn off image decoding
**END SETTING**
**Data Matrix**
**Start Setup**
Enable Rectangular Data Matrix (default)
Close Rectangular Data Matrix
**END SETTING**
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.