This article introduces the setting method of "GS1 DataBar 14", which is suitable for finding the corresponding configuration barcode and completing parameter adjustment.
Applicable to:
C990, I5, I8, W8-WIFI, W8-X, W9, W9S, NT-1202, NT-1202W, CS8501, GY-20U, GY-30U, GY-50U, GY-60U, NT-90
Questions
- How to set up GS1 DataBar 14?
- Where is the GS1 DataBar 14 setup code?
- How to adjust the parameters of GS1 DataBar 14?
Resolution / Answer
This setting is used to control the additional characters and output mode at the end of the scanned data or during the output process. It is usually used when you need to automatically wrap lines, jump to the next input box, or adjust the data output format after scanning the QR code.
**GS1 DataBar 14**
**Start Setup**
Enable GS1 DataBar 14 (default)
Close GS1 DataBar 14
**END SETTING**
**GS1 DataBar 14**
**Start Setup**
Enable GS1 DataBar 14 Stacked
Turn off GS1 DataBar 14 Stacked (default)
**END SETTING**
**GS1 DataBar 14**
**Start Setup**
Output AI (01) characters (default)
Do not output AI (01) characters
**END SETTING**
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.