This article introduces the setting method of "ring tone", which is suitable for finding the corresponding configuration barcode and completing parameter adjustment.
Applicable to:
E900
Questions
- How to set a beep sound?
- Where is the beep configuration barcode?
- How to adjust the beep parameters?
Resolution / Answer
This setting controls the device's sound, lighting, aiming, or image-related feedback. It is usually used when you need to reduce the beep sound, confirm the scanning status, improve lighting positioning, or adjust the image reading effect.
By sending the __ring tone__ command, you can control the scanner to sound a tone. The frequency and duration of the beep need to be configured as parameters of the __ring beep__ command. The command format is BEEPON xxxFyyyTnnV, where: F represents the frequency of the prompt tone, the value range is 1 ~ 20000Hz, xxxF represents the frequency of the prompt tone is xxx Hz (for example, 2700F represents the frequency of the sound is 2700Hz); T represents the duration of the prompt tone, the value range is 1 ~ 10000ms, yyyT represents the duration of the prompt tone is yyy ms (for example, 100T means the sound duration is 100ms); V means volume, the value range is 1~20.
Emit a sound with a frequency of 2000Hz, a duration of 50ms, and a volume of 20V:
Send ~<SOH>0000#BEEPON2000F50T20V;<ETX>
Reply <STX><SOH>0000#BEEPON2000F50T20V<ACK>;<ETX>.
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.