This article introduces the setting method of "Serial Trigger Command", which is suitable for finding the corresponding configuration barcode and completing parameter adjustment.
Applicable to:
E900
Questions
- How to set up the serial trigger command?
- Where is the serial trigger instruction configuration barcode?
- How to adjust the serial trigger command parameters?
Resolution / Answer
This setting controls when the device starts scanning, how long it lasts, and how continuous scans are handled. It is usually adjusted when manual triggering, automatic sensing, avoiding repeated output or improving scanning response speed are required.
When the decode mode is set to level trigger mode, it supports triggering code reading through the serial communication command "Start Code Reading". The scanner will end code reading after successful reading or reaching __one code reading timeout__ or receiving the "Stop Code Reading" command.
u Disabled: Do not use serial trigger instructions
u Enable: Use serial trigger instructions in level trigger code decode mode
Big [Prohibited]
Scan the following barcode to configure it will be [Prohibited].
[Enable]
Scan the following barcode to configure [Enable].
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.