This article introduces the setting method of "Default Parameters", which is suitable for finding the corresponding configuration barcode and completing parameter adjustment.
Applicable to:
CS9501, E950, RS-9000BT, RS-9000PT, RF5520, RF5520U
Questions
- How to set default parameters?
- Where is the default parameter configuration barcode?
- How to adjust the default parameters?
Resolution / Answer
This setting is used to restore device parameters to the default or preset state. It is usually used when the parameters are changed, the current configuration cannot be confirmed, or when it is necessary to quickly switch to a common working mode.
The PL3307 can be reset to two types of defaults: factory defaults or custom defaults. Scan the appropriate barcode below to reset the decoder or save the current settings as custom defaults.
- **Restore Defaults**: Scan this barcode to restore all default parameters:
- If you have previously set a custom default via "Write Custom Default", scanning "Restore Default" will retrieve and restore the custom default.
- If no custom defaults have been set, scanning "Restore Defaults" will restore the factory defaults listed in Table A-1.
- **Set Factory Defaults**: Scanning this barcode will restore the factory defaults listed in Table A-1 and delete any custom defaults that have been set.
- **Write Custom Defaults**: Scan this barcode to save the current decoder settings as a custom default. After setting, it can be retrieved by scanning "Restore Defaults".
* Restore default value
Scan the following barcode to * restore default values.
Set factory default values
Scan the following barcode to set factory defaults.
Write custom default value
Scan the following barcode to write custom default values.
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.