This article introduces the setting method of "Beep after decoding", which is suitable for finding the corresponding configuration barcode and completing parameter adjustment.
Applicable to:
CS9501, E950, RS-9000BT, RS-9000PT, RF5520, RF5520U
Questions
- How to set the beep after decoding?
- Where is the beep configuration barcode after decoding?
- How to adjust the beep parameters after decoding?
Resolution / Answer
This setting controls the device's sound, lighting, aiming, or image-related feedback. It is usually used when you need to reduce the beep sound, confirm the scanning status, improve lighting positioning, or adjust the image reading effect.
* Beep after decoding (enabled) (01h)
Scan the following barcode, * beep (enabled) (01h) after decoding.
No beeping after decoding (disabled) (00h)
Scan the following barcode to it will not beep (disabled) after decoding (00h).
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.