This article introduces the setting method of "Power Mode (Serial Host Only)", which is suitable for finding the corresponding configuration barcode and completing parameter adjustment.
Applicable to:
CS9501, E950, RS-9000BT, RS-9000PT, RF5520, RF5520U
Questions
- How to set the power mode (serial host only)?
- Where is the configuration barcode for power mode (serial host only)?
- How to adjust the power mode (serial host only) parameters?
Resolution / Answer
This setting is used to configure the communication method or communication parameters between the device and the host. Usually when connecting to a computer, serial device, RS485/Modbus network or access control Wiegand system, you need to ensure that the parameters at both ends are consistent.
Select whether the decoder enters low power mode after a decoding attempt. In "continuous power" mode, the decoder does not enter this low-power state.
Continuous power supply (00h)
Scan the following barcode for continuous power supply (00h).
* Low power mode (01h)
Scan the following barcode, * Low Power Mode (01h).
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.