This article introduces the setting method of "same symbol decoding interval", which is suitable for finding the corresponding configuration barcode and completing parameter adjustment.
Applicable to:
CS9501, E950, RS-9000BT, RS-9000PT, RF5520, RF5520U
Questions
- How to set the same symbol decoding interval?
- Where is the code for setting the same symbol decoding interval?
- How to adjust the same symbol decoding interval parameter?
Resolution / Answer
This article introduces the use and configuration method of "same symbol decoding interval". Usually refer to this article when you need to change the default behavior of the device, adapt to the business system, or find the corresponding configuration barcode.
Use this option in Demonstration Mode or Continuous Reading Mode to prevent multiple rereads of the same barcode that remains within the decoder's field of view. This timeout begins when the barcode moves out of the field of view.
To select a same-symbol decoding interval (0.0 to 9.9 seconds in 0.1-second steps), scan the barcode below, and then scan the two digit barcodes in Appendix D, "Numeric Barcodes," to specify the interval. Default is 0.6 seconds.
Note: "Same symbol decoding interval" must be greater than the value of "Different symbol decoding interval".
Same symbol decoding interval
Scan the following barcode to configure with the same symbol decoding interval.
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.