This article introduces the setting method of "/Disable Trioptic Code 39", which is suitable for finding the corresponding configuration barcode and completing parameter adjustment.
Applicable to:
CS9501, E950, RS-9000BT, RS-9000PT, RF5520, RF5520U
Questions
- How to enable/disable Trioptic Code 39?
- How to turn off/disable Trioptic Code 39?
- / Where is the switch setting to disable Trioptic Code 39?
Resolution / Answer
This setting is used to control the reading, verification, length or output rules of the specified barcode type. It is usually used when certain types of barcodes cannot be scanned, the misreading rate is high, or when it is necessary to limit the reading of barcodes in specific formats.
Trioptic Code 39 is a variant of Code 39 used for marking computer tape cartridges, the symbol is always 6 characters long. Scan the appropriate barcode below to enable or disable.
Enable Trioptic Code 39 (01h)
Scan the following barcode to enable Trioptic Code 39 (01h).
* Disable Trioptic Code 39 (00h)
Scan the following barcode, * Trioptic Code 39 (00h) is disabled.
Note: Trioptic Code 39 and Code 39 Full ASCII cannot be enabled at the same time.
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.