This article introduces the setting method of "Transmitting US Postal Check Digit", which is suitable for finding the corresponding configuration barcode and completing parameter adjustment.
Applicable to:
CS9501, E950, RS-9000BT, RS-9000PT, RF5520, RF5520U
Questions
- How do I set up the US Postal Check Digit for transmission?
- Where is the transmitting US Postal Check Digit Setting Code?
- How to adjust the transmission US postal check digit parameters?
Resolution / Answer
This setting is used to configure the communication method or communication parameters between the device and the host. Usually when connecting to a computer, serial device, RS485/Modbus network or access control Wiegand system, you need to ensure that the parameters at both ends are consistent.
Select whether to transmit US postal data (including US Postnet and US Planet) with a checksum bit.
* Transmit US Postal Check Digit (01h)
Scan the following barcode, * to transmit the US Postal Check Digit (01h).
Do not transmit US postal check digit (00h)
Scan the following barcode, the US Postal Check Digit (00h) is not transmitted.
If this does not resolve the issue, please reset the barcode scanner or contact us. Click here to find your barcode scanner model and perform the reset.